Skip to main content

Model Irregular Pipe Geometries With Process Safety Office® - Technology Updates / News - iOiQ Software Support

Nov 15 2017

Model Irregular Pipe Geometries With Process Safety Office®

Authors list

Visio 2016 and Microsoft® Office 365 Support:  

All components of Process Safety Office® which are integrated with Visio® for visual arrangement and representation are now fully supported with the latest Visio® versions. These components include ioLogic™, ioVu™ (for relief/process piping isometric), and SuperChems™ flow network and process flow diagram capabilities. Our software supports both 32-bit and 64-bit platforms. 

 

Model Irregular Pipe Geometries: 

Starting in Process Safety Office® v8.3 using the SuperChems™ component, users can model flow from various irregular pipe geometries such as cracks, rectangular ducts, annulus (pipe in pipe), elliptical pipes, and parallel equivalent pipes. Typical applications include loss of containment estimates from equipment’s cracks and pump/compressor seal or angular flow geometry.

 

 

ioMosaic is committed to leveraging the latest technology to maximize tool performance. Check back often to see the latest information about ioMosaic software and technology solutions.

Helpful Unhelpful

25 of 58 people found this page helpful

ioMosaic Corporation | Privacy Policy | Terms of Use | | |